在濟南裝修，墻面處理是重中之重，而刮膩子作為墻面裝飾的基礎工序，直接決定后續乳膠漆效果和墻面耐用度。很多業主裝修完沒多久，就出現墻面開裂、掉皮、返潮等問題，多半是刮膩子前沒跟師傅溝通到位，忽略了關鍵細節。今天就跟濟南業主嘮透，刮膩子前必須跟師傅確認的11件事，用好濟南膩子粉，裝出平整耐用的好墻面。

　　In Jinan decoration, wall treatment is of utmost importance, and scraping putty as the basic process of wall decoration directly determines the subsequent latex paint effect and wall durability. Many homeowners experience problems such as wall cracking, peeling, and moisture regain shortly after finishing their decoration, mostly due to a lack of communication with the master before applying putty and neglecting key details. Today I talked to the owners in Jinan about 11 things that must be confirmed with the master before applying putty. Use Jinan putty powder well to create a smooth and durable wall.

　　第一件事，刮膩子前務必鏟凈舊墻皮。這是墻面平整的基礎，濟南不少老房子墻面有舊涂層、浮灰或疏松表層，若不徹底鏟除，后期膩子容易脫落、起鼓，哪怕用再好的濟南膩子粉也沒用，師傅必須逐面清理，確保基層干凈堅實。

　　The first thing is to clean the old wall surface before applying putty. This is the foundation of a smooth wall. Many old houses in Jinan have old coatings, floating dust or loose surfaces on their walls. If not thoroughly removed, the putty is prone to peeling and bulging in the later stage. Even the best Jinan putty powder is useless. The master must clean each surface to ensure that the base is clean and solid.

　　第二件事，重點部位必須掛網防開裂。水電開槽處、新舊墻體交接處、石膏板接縫處，是墻面開裂的高發區，一定要讓師傅局部掛網；如果是輕體墻、保溫墻，建議滿墻掛網，借助網格布的拉力，減少墻面收縮開裂的概率，這在濟南潮濕天氣里尤為重要。

　　The second thing is that key areas must be covered with nets to prevent cracking. The areas where water and electricity are slotted, where new and old walls intersect, and where gypsum board joints occur are high-risk areas for wall cracking. It is necessary to have the master partially hang the mesh; If it is a lightweight wall or insulation wall, it is recommended to hang a mesh throughout the wall and use the tension of the mesh cloth to reduce the probability of wall shrinkage and cracking, which is particularly important in humid weather in Jinan.

　　第三件事，靠衛生間墻面先做防水找平。濟南不少戶型衛生間與臥室、客廳相鄰，墻面易返潮，靠近衛生間的墻面，需先刷一層防水，再用石膏找平，避免后期墻面返潮、發霉，影響膩子附著力和居住體驗。

　　The third thing is to first waterproof and level the bathroom wall. Many bathroom units in Jinan are adjacent to bedrooms and living rooms, and the walls are prone to moisture regain. The walls near the bathroom need to be coated with a layer of waterproofing first, and then leveled with plaster to avoid moisture regain and mold on the walls in the later stage, which will affect the adhesion of putty and the living experience.

　　第四到五件事，全屋石膏找平和陰陽角條不能少。全屋石膏找平能解決墻面凹凸不平的問題，為后續刮膩子打下基礎；全屋做陰陽角條，能讓墻面邊角整齊挺拔，避免后期乳膠漆涂刷后出現毛刺、不規整的情況，提升整體顏值。

　　The fourth to fifth thing is to level the entire house with plaster and ensure that there are no missing corners. Whole house gypsum leveling can solve the problem of uneven walls and lay the foundation for subsequent putty application; Making internal and external corner strips throughout the house can make the wall edges neat and straight, avoid burrs and irregularities after latex paint application, and enhance the overall appearance.

　　第六件事，必須刷墻固增強附著力。濟南部分新房墻面基層疏松，刷墻固能固化基層、減少起砂，讓濟南膩子粉更好地貼合墻面，從根源上避免膩子脫落，這一步千萬別省，很多師傅會默認省略，業主一定要提前叮囑。

　　The sixth thing is to fix the wall and enhance adhesion. Some new houses in Jinan have loose base layers on their walls. Brushing the walls can solidify the base layer and reduce sanding, allowing Jinan putty powder to better adhere to the walls and prevent putty from falling off at the root. This step should not be omitted, as many masters may default to it. Homeowners must advise in advance.

　　第七件事，膩子中嚴禁加膠水。不少老手藝師傅習慣加膠水提升膩子粘性，但膠水多含甲醛，既不環保，還可能因收縮導致墻面開裂?，F在優質濟南膩子粉本身粘性足夠，無需額外加膠，堅守這一點，兼顧環保與墻面耐用度。

　　The seventh thing is that it is strictly prohibited to add glue to putty. Many skilled craftsmen are accustomed to adding glue to enhance the stickiness of putty, but the glue often contains formaldehyde, which is not environmentally friendly and may also cause wall cracking due to shrinkage. Nowadays, high-quality Jinan putty powder has sufficient viscosity and does not require additional adhesive. We adhere to this principle while balancing environmental protection and wall durability.

　　第八到十件事，把控干燥節奏和涂刷流程。膩子必須完全干透后再刷乳膠漆，濟南潮濕季節可適當延長干燥時間，避免后期墻面起鼓、發霉；乳膠漆施工要遵循“一底兩面”原則，先刷底漆，底漆能封閉基層、提升面漆附著力，再刷兩遍面漆，第二遍需等第一遍干透，防止流掛、色差。

　　The eighth to tenth things are to control the drying rhythm and painting process. Putty must be completely dried before applying latex paint. During the humid season in Jinan, the drying time can be appropriately extended to avoid later wall bulging and mold growth; The construction of latex paint should follow the principle of "one bottom, two sides". First, apply the primer, which can seal the base layer and improve the adhesion of the topcoat. Then apply two coats of topcoat, and wait for the second coat to dry completely to prevent sagging and color difference.

　　第十一件事，提前扣緊開關插座底盒。刮膩子前讓師傅把開關、插座底盒扣緊固定，避免膩子進入底盒內部，后期清理困難，也能防止開關插座安裝時與墻面銜接不平整，影響美觀。

　　The eleventh thing is to fasten the bottom box of the switch socket in advance. Before scraping putty, ask the master to fasten and fix the bottom box of the switch and socket to prevent putty from entering the inside of the bottom box, which will be difficult to clean later. It can also prevent uneven connection between the switch and socket installation and the wall, which will affect the appearance.

　　對濟南業主來說，刮膩子看似是師傅的手藝活，實則離不開前期的細致溝通。很多墻面問題，并非濟南膩子粉質量不佳，而是忽略了這些關鍵工序。提前跟師傅聊透這11件事，明確施工標準，既能避免后期返工，又能讓墻面保持平整美觀，耐用十年不翻車。畢竟墻面是裝修的“臉面”，基礎打扎實，后續裝飾才能更出彩。

　　For homeowners in Jinan, scraping putty may seem like a master's skill, but in reality, it cannot be separated from meticulous communication in the early stages. Many wall problems are not caused by poor quality of Jinan putty powder, but by neglecting these key processes. Talk to the master in advance about these 11 things, clarify the construction standards, which can not only avoid rework in the later stage, but also keep the wall flat and beautiful, durable for ten years without overturning. After all, the wall is the "face" of decoration. Only with a solid foundation can the subsequent decoration be more outstanding.